![]() I decided I did not really want to mess with it any longer, because things seemed kind of flaky and unrealiable - but that was obviously just my experience - I gave up after how easy the gopro worked. I did not end up liking my setup though, atleast not once I got my gopro, so I returned the Git2. They have the free designs cataloged and the websites software does all the 3D printing calculations automatically (even lets you know if the part will not print correctly) and you do not have to get into all the nitty gritty of 3D printing stuff. ![]() The parts turned out really well and I got um relatively cheap because I ordered several parts at the same time all with the same base specs (color, fill-ratio, etc.) so I was only charge one $10 setup fee (the parts themselves cost anywhere from $1.50 - $6 depending on what I was buying and how many I was ordering. The 3D printed parts are available and i purchased from "", their 3D Co-OP-like printing service. The stock solo gimbal HDMI connector works on this camera after you cut away a bit of the plastic underneath the connector - careful not to slice into the rubber covering the HDMI cable as I did, nearly slicing the wire, making my backup gimbal useless. The gimbal functions as smooth as it did with a GoPro. Testing the audio (sound) quality of GIT2 action camera by GitUp. With this camera, you can record 2.7K 24FPS video and. The fact that the Git2P weighs 23grams less than the GoPro Hero 4 Black helps. Gitup GIT2 Sound Audio Test Internal vs External microphone. The GitUp Git 2 uses Sony Exmor IMX206, including Gyro stabilization and in-built microphone and speaker. I was worried the gimbal would have a problem with the new camera sitting a quarter of an inch forward but it was not a problem. A small amount of trimming of plastic corner under the HDMI cable solved this problem. Charging / external microphone cable test: Git2: 20: Apr 17, 2017: Similar threads External mic(s) not working: External power and mic: Using an external mike while in waterproof case: Git2P External Power Selector. ![]() The HDMI cable was a couple of mm to short to plug into the camera. Velcro is simple and secure plus it makes it easy to change cameras. I use a Velcro strap to hold the camera in place. Then I carefully cut off the rounded tab, on the left side, that was used to hold a GoPro, but was now in the way. Since the GIT2P has to sit in front of the connector, I made a quarter inch thick pad for the camera to rest against (see photo), using the black dense foam that came with the gimbal. I did not want to remove it, because I still want to be able to use it with a GoPro. The first problem I had to deal with was the connector that plugs into the back of a GoPro. Use of this camera required some modifications to the SOLO gimbal, but I made sure that I can still use a GoPro if I want.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |